Gorenje GBFU 200 E

Классно греет воду. Скорость нагрева высокая и помыть голову, например, можно буквально через час. Ну а если замахиваться на что-то более глобальное типа ванны, то нужно греть весь бак на максимуме и это, конечно, уже совсем другие сроки. Зимой, когда вода холодная, такой подогрев занимал больше трех часов. Но на максимуме мы греем воду редко. Чаще всего регулятор стоит в позиции ECO. И воды с температурой в 50-55 градусов нам хватает. Режим интересен тем, что он оптимален с точки зрения расхода электроэнергии и тепловых потерь. Ну и накипи на ТЭНах образуется, конечно, меньше. ТЭНы в нем стоят не обыкновенные, погружные, а так называемые "сухие". То есть сам такой ТЭН с водой не контактирует, а греет ее через промежуточную эмалированную стенку. Вроде бы такие ТЭНы долговечнее обычных, но это только время покажет. Имеет электронное управление и это не только удобно, но и за счет высокой точности контроля температуры позволяет экономить электроэнергию.

The large volume of the tank allows you not to shake over every drop of hot water. Enough for bathing, showering, laundry and other household and kitchen needs. It can heat up to a decent 75 degrees and after mixing with cold water, 100 liters turn into more than two hundred. Good tank protection against corrosion. Inside, it is covered with a high-quality glass-ceramic coating and additionally protected electrochemically by a sacrificial magnesium anode. Able to signal the wear of the magnesium anode. A useful feature, because otherwise it is impossible to understand what is happening with this anode and in what state it is. Of course, you can follow the instructions and disassemble the boiler annually, but no one among my friends does this. Clean and change the anode a maximum of once every two years. Useful and profitable ECO-mode. When activated, the water heats up to a maximum of 50-55 degrees, which is beneficial both in terms of heat loss and to reduce the formation of scale. Scale in it, thanks to the so-called dry heating elements, forms very little.

Thanks to two kilowatt tubular electric heaters, the tank heats up very quickly. The heaters themselves are not ordinary, but "dry". This is a relatively new technology, when the heater does not have its own durable housing and heats water through the wall of the flask built into the tank. It turns out that a small air gap remains between the fuel element of the heater and the wall. With such an arrangement, scale formation is impossible on the heating element, and the heater itself, due to the lack of contact with water, works many times longer. The heaters are connected in parallel, i.e. if one of them fails, the second one will continue to heat the water and the boiler will not lose working capacity. I personally mostly operate it in ECO mode. Water at the same time is not heated to the maximum, but only up to 50-55 degrees. At this temperature, heat losses through the boiler wall are almost halved, and scale does not form on the walls of the flasks at all. Electronic control, which saves about 10% of electricity. Quite accurately determines and displays the temperature of the water in the tank.