Comparison Terra Incognita MaxLite 2 vs Terra Incognita Alfa 2

Seasons in which the use of a tent is allowed.

There are three main seasonality options: winter, spring / autumn and summer. At the same time, the design features necessary for comfortable use of the tent in different seasons are as follows:

— In winter, the tent should effectively protect against snow and wind, and its materials and fittings should normally endure a long stay in the cold. Thermal insulation is also desirable, but in general this is a secondary factor — the main insulation is provided primarily by clothing, a sleeping bag and a bed.
— In the off-season — in spring and autumn — protection from rain, which can be accompanied by strong winds, is of particular importance.
— For comfortable use in the summer heat, good ventilation is required, ideally with insect protection, such as mosquito nets.

As you can see, these requirements generally do not contradict each other and may well be combined in one product. Thus, there are very few tents on the market designed strictly for one season — two- or even all-season options are much more common. For example, even among beach tents (see "Purpose") there are models for which the possibility of using in the off-season is claimed — for this, the design provides for a dense awning, or even the ability to completely close the tent. Almost any model from the "spring-autum...n" series additionally has a summer specialization; and most models suitable for winter actually allow year-round use.

In conclusion, we recall that tents with the same seasonality and purpose can at the same time differ significantly in characteristics and design features.

The total weight of the tent is including the frame and other accessories.

This parameter depends primarily on the purpose (see above), and after that — on seasonality, capacity, and additional functions. For example, in trekking and expedition models, the weight usually does not exceed 5 – 7.5 kg, and the lightest of these products can weigh 2 – 3 kg or even less, while being full-fledged tents for 2 people or even more. However, for a trekking tent, such a small weight with a capacity of more than 2 people usually means that this model is designed exclusively for the summer. For most camping tents, the weight starts at 6 kg, although among them there are also quite light products — by 4 – 5 kg, 3 – 4 kg, or even less (in such cases, light weight can also mean a purely summer specialization). And the most capacious and/or multifunctional models can have a weight of 10 – 15 kg, 15 – 20 kg and even more; in this weight category, you can mainly find tents, camping tents for many people and fishing tents for carp fishing (see "Destination").

When choosing a tent according to this indicator, it is worth considering that it does not always make sense to chase the maximum we...ight reduction. Yes, the light tent is the most convenient to carry; on the other hand, weight reduction inevitably affects one or several other characteristics at once. So, most often, lighter models are either more expensive or smaller in size and less roomy and functional than their heavier counterparts. And sometimes weight reduction also negatively affects the security (including moisture resistance) and the overall reliability of the product. Therefore, it makes sense to specifically look for the lightest tent possible in cases where weight reduction is of key importance; a typical example is long trips, in which all the equipment has to be carried “on oneself” for a long time. And even in such cases, it is worth remembering other important characteristics. For example, for use in late autumn, when frosts are likely, it is better to choose a heavier tent with winter seasonality than a light model that is not designed for winter conditions.

The vestibule is a kind of "entrance hall" in front of the entrance to the main compartment (s) of the tent.

The specific design and purpose of such a "hallway" may be different. So, in small two-layer tents, the space between the inner and outer layers in front of the entrance plays the role of a vestibule (for this, the outer canopy is stretched at a greater angle relative to the vertical than the inner one). The dimensions of such a compartment are small, it is designed mainly for storing individual items, such as shoes. In larger models, the vestibule is made in the form of a full-fledged compartment, which differs from the main compartment only in the absence of a bottom (although there are exceptions). Such a compartment can be located between two sleeping compartments; and in some tents two vestibules are provided at once.

Anyway, such equipment increases the useful area of \u200b\u200bthe tent and provides additional comfort when using it. Tambour can be used to store equipment, often quite bulky; with an open entrance, it provides additional protection for the main volume of the tent from rain, sun and wind; and in a large vestibule(150 cm long or more), you can even organize additional sleeping places (if the weather permits) or even an auxiliary room such as a kitchen, dining room, administrative area, etc. " below.

Both the rigidity of the frame and the reliability and durability of the tent itself depend on the thickness of the arcs. Usually, the larger and more capacious the tent, the thicker the arches are needed for the frame. Arcs made of plastic and fibreglass most often have a thickness of 7 to 13 mm, while steel and aluminium — from 5 to 16 mm. With an increase in the section of the arcs, the weight of the tent in the folded state also increases.

The material from which the frame of the tent (arc) is made. The main requirements for arcs are strength, resistance to deformation (elasticity) and low weight. Modern tents use several materials with different ratios of these parameters.

— Aluminium. A fairly common material: it has good strength characteristics and low weight, but it is relatively inexpensive. At the same time, aluminium is prone to deformation under long-term stress (although this is usually not critical even when parking for several days).

— Fibreglass. Composite material based on a combination of fibreglass and plastic. The main advantage of fibreglass is resistance to deformation: even under prolonged loads, the arcs do not lose their shape. In addition, this material is cheap and light in weight (although somewhat heavier than aluminium). The disadvantage of fibreglass is its sensitivity to low temperatures, which limits its use in winter conditions and at high mountains. However, most people use tents in the warm season, and therefore fibreglass has recently gained considerable popularity.

— Steel. Steel is the most durable of the described materials, in addition, it holds loads well, almost without deforming. At the same time, steel arcs have a significant weight, and therefore they are rarely used in tents.

— Durapol. A composite material that...has appeared relatively recently and is positioned as a more advanced alternative to fibreglass. Durapol has a "puff" design: the outer layer is made of special polymer resins, metal foil is located under it, a synthetic mesh is located under it, and, finally, a layer of fibreglass. According to the creators, arcs made of this material are more durable and resistant to fracture than fibreglass, better tolerate low and high temperatures, as well as ultraviolet radiation, are less susceptible to residual deformations and have less weight.

An indicator that reflects the ability of the tent awning to withstand moisture without getting wet. It is expressed in millimetres of water column — the height of the water column that the awning can withstand (the area of impact is out of the question, because the load per unit area under water depends only on the height of the water column and is not related to the area of \u200b\u200bits base). The significant figures indicated in the characteristics (for example, 4000 mm of water column, i.e. 4 metres) are due to the fact that raindrops can have a significant speed and, when they hit the tent, create a load at the point of impact comparable to the pressure on depth of several metres.

In general, the higher the waterproof rating, the better the awning will cope with the effects of rain and snow. Indicators up to 3000 mm w.c. Art. are considered sufficient for places where it rains rarely, awnings for 3000 – 7000 mm of water. Art. allow you not to be afraid of intense downpours, and in expeditionary (see "Destination") tents designed for extreme conditions, this figure can reach 10,000 mm of water. Art. and even more. However, more water-resistant fabrics, usually, have a significant weight, so in each individual case it makes sense to choose the option that is optimal in terms of durability and weight.

— Polyester. Synthetic material with good durability and waterproof performance. In addition, it is resistant to adverse effects (does not lose strength when wet, exposed to acidic and alkaline environments, temperature changes).

— Nylon. In general, the characteristics of nylon are somewhat lower than those of polyester: it tends to stretch when wet and is generally less resistant to adverse effects. At the same time, given that most owners use tents in relatively simple conditions, these points are not critical; in addition, some manufacturers use a special treatment to improve the durability of nylon.

— Polyethylene. This material is mainly used in inexpensive models of camping tents (see "Purpose") — this is primarily due to its significant weight. For other characteristics, it does not have key differences from other materials.

— Polyamide. The general name for a class of fabrics, which includes, in particular, nylon and nylon. Some manufacturers use this term for marketing purposes: "polyamide" sounds more solid than "nylon", although these materials practically do not differ in characteristics and are used in the same way — mainly in inexpensive models.

An indicator that reflects the degree of resistance of the bottom of the tent to moisture. For more information about the features of measuring this indicator, see "Tent waterproofness". Here also note that, for obvious reasons, the bottom, unlike an awning, is practically not subject to rain drops — as a result, the requirements for bottom water resistance are significantly lower. So, fabrics with a water resistance of 3000 mm of water. Art. are considered absolutely waterproof (up to the possibility of putting a tent in a puddle), and higher values usually indicate an increased thickness of the fabric and corresponding strength and wear resistance. Just like with an awning, more waterproof fabrics tend to have a significant amount of weight, so it doesn't always make sense to look for bottoms with maximum water resistance.