Fan heater Ballu BFH/C-20

₀

₁

₅

₀

good model, I liked it

30 October 2016

At work, the heating was again delayed, and since a retired colleague took his oil cooler out of the room in the spring, I had to solve this problem alone. In fact, there are not very many options: an oil heater, a convector, an infrared emitter and a fan heater. I chose a fan heater, as this is the fastest way to catch up with a comfortable temperature. And, compared to other options, it is the most compact and lightweight, which means that it can be quickly transferred from another room, where I sometimes linger for a long time.

The heating rate is just phenomenal. In the second half of October, in the mornings, I came to work and found myself in a room with a temperature no higher than +14 degrees. This kid heated it up to +19…+20 in just 30-40 minutes. For comparison, I will say that the previous 2 kW oil heater did the same thing in an hour and a half. The room is small, about 11 square meters, and now it is always warm in it. The air is heated by ceramic plate heating elements. This is much better than open coiled heaters, if only because their surface heats up much less than the surface of thin nichrome wire. And this, in turn, means that the dust that gets on them does not burn out and does not emit unpleasant odors. And this model is equipped with a thermostat that helps maintain a constant temperature.

The strange logic of the thermostat, due to which, when the desired temperature is reached, the heating element turns off, but the fan continues to spin. Short electrical cord, which required the use of an extra extension cord.

Discuss

Show Original

1 out of 6 user review(s) shown

5 more user review(s)