Cooler Master MasterBox E500L blue (MCB-E500L-KN5N-S00)

I'll tell you about the "nuances" (or rather idiotic decisions)
1. Acrylic side panel (org glass), CoolerMaster said they will not do it with tempered glass.
2. There is no dust filter on top of magnets like in normal cases, holes are simply drilled and molding is done. The dust filter itself is there, but it is attached from the inside with plastic clips - not a quick-release one. It gets clogged - you need to remove the valves, and when removed, all the dirt will fall on the mother and the cooler of the processor (most likely, but not a fact)
3. On the "muzzle" between the slider and the dust mesh, there are two square holes that go nowhere, or rather into the slider itself, from where the air has nowhere to come from.
4. If you insert headphones or a microphone, the slider will cover the already small hole from below. Therefore, I would fasten the valves from the inside of the case, and not inside the plastic "muzzle" for better ventilation
5. Half-removable HDD tray - the height of insanity! Under the case, just where the tray is, there is a place for a vent (120?) and 2.5 ssd / hdd. How to install them if the tray is riveted on one side?
6. The top fans will be close to the tower cooler, above the motherboard, that is, the motherboard, as it were, "will drop in" a little under the top turntables. Therefore, if you, like me, have a cooler mounting hook sticking out, then you will not install the top fan, which is closer to the back of the case. From here, there will also be a problem with removing the RAM, since one side will be under the turntable housing.
7. From the bottom, removing the HDD basket, you can install 120 vents only if the PSU is of a standard length and without installation. casing