Working distance range of parking sensors; in other words, this is the interval from the response threshold to the smallest distance at which the device is still able to provide sufficiently reliable data on the distance to the obstacle.
The threshold of operation of modern devices usually does not exceed 3 m, and more often it is in the range of 1.5 – 2.5 m; the sensors themselves are capable of providing a longer range, but in fact there would be little benefit from this, but there are plenty of reasons for unnecessary worries. The minimum distance, usually, is 0.1-0.3 m (10-30 cm); a closer entrance is usually perceived by the device as a close approach, with a corresponding indication (for example, the transition of the sound signal to continuous). And if the response threshold is more of a reference value, then you should pay closer attention to the minimum distance, especially if you often have to deal with cramped conditions (for example, manoeuvring at a difficult entrance to a small garage). Indeed, in such cases, it is important that the parking sensors retain the ability to accurately indicate the distance for as long as possible, without switching to the “close” mode.
A way to display information about the distance to obstacles, as well as about some other aspects of the parking sensors.
—
Sound only. The simplest and least visual type of indication — data on obstacles are given in the form of an audible signal. Most often, these are intermittent signals that become more frequent as the sensors approach an obstacle and turn into a continuous squeak when approaching a dangerous distance (less than the minimum detection distance, see above). Audible-only models are inexpensive and also easy to install because the signal box does not need to be placed directly in front of your eyes. However, on their own, they provide only very approximate distance data and are more suitable as additional collision insurance than as a full-fledged “parking aid”. Therefore, many models of this type provide the ability to connect an external monitor (see "Functions / Capabilities"), which expands the display options. And options without such an opportunity are quite rare, mainly among low-cost models.
—
LED bulbs. Indication using a set of LEDs (LED — light emitting diode); it can be not only spotlights, but also luminous indicators from rectangular blocks. Nevertheless, the general principle of operation is the same everywhere: the smaller the distance to the obstacle, the more lights are on; and in many models the indicators can be made in different colours, with
...those closest to the minimum distance usually made red. Such informing is much more visual than sound: usually, each light on / off indicator means a change in distance by a strictly defined value, which allows you to fairly accurately assess the situation. In addition, many of these models can be equipped with digital indicators (see "Functions / Capabilities"), and they are relatively inexpensive. As a result, LED bulbs are one of the most common types of indicators, especially in mid-range models.
— Display. The most advanced type of display, which implies the presence of a full-fledged screen. Parking sensors of this type are the most expensive, however, their functionality is very wide: after all, a wide variety of information, both digital and graphic, can be displayed on the screen, up to the “picture” from the reversing camera. However full-fledged displays (as in TVs, GPS-navigators, etc.) are the prerogative of premium-class devices. Simpler models usually have a design based on the so-called banners — ready-made inscriptions, pictures, etc., which are highlighted ("light up") in appropriate cases.
Note that the last two types of indication can be supplemented by a sound signal (and most often they are supplemented), and displays can be combined with LED indicators; in such cases, belonging is determined by the most advanced type of indication provided for in the design. It must also be said that the already mentioned digital distance indicator does not by itself turn the LED indicator into a full-fledged display — this requires other additional features.—
Digital distance indicator. With this function, the parking sensors not only signal the approximate distance to the obstacle, but display the specific value of this distance in the form of numbers (usually in metres) on the display. Such information is much more accurate and clearer than the data from the LED panel and, moreover, from the sound signaling device.
—
Voice notification. This function expands the possibilities of sound signaling: the device can emit not only certain conditional signals, but also voice various information in a voice format. The specific possibilities may be different, depending on the model: some parking sensors speak information about the distance at certain intervals, others specify which side the sensors were triggered from (not only front or rear, but also right or left) and much more.
—
Sound volume adjustment. The ability to change the volume of the parking sensors sound signals at your discretion: for example, when parking on a noisy street, increase it so that you are guaranteed not to miss a single notification, and reduce it in a quiet underground garage so that the sounds “do not hit your ears”. In addition, the perception of sounds may differ for different people, and the same signal may turn out to be normal for someone, too loud for someone, and excessively quiet for someone.
—
Memory of external elements. Remote elements mean various external parts of a car located in the area of \u200b\u200bbumpers: "reserve wheels", tow bars, "kenguryatniki" grilles, etc. Their location is different, and it is possible that such a part falls into the range of parking sensors and is perceived as an external obstacle. To avoid such false positives, a memory function is provided: the device “remembers” the pattern of the reflected signal from the remote elements, and issues a warning only when real obstacles are within the detection distance.
—
Video input (to the camera ZV). A connector that allows you to connect a reversing camera to the parking sensors. This provides a very high degree of control over the situation: if the parking sensors themselves, at best, signal the approximate location of obstacles, then the camera allows you to see what exactly is on the way (moreover, in the “dead zone” right behind the bumper, not blocked by rear-view mirrors). Of course, to view data from the camera, a full-fledged display is required: some parking sensors have their own (see "Indication"), others provide connecting an external monitor via a video output (see below).
—
Video output (to the monitor). A connector for connecting a fully functional external screen to the parking sensors — for example, a car TV or a GPS navigator. Usually found among devices with LED bulbs or a sound signal (see "Indication"): much more information can be displayed on an external screen than on standard indicators. However, even in models with their own display, this function may be useful — after all, the capabilities of this display can be much more modest than that of a full-fledged screen.
—
Reversing camera included. The meaning of this feature is already clear from the name: by purchasing such a kit, the driver immediately receives both the parking sensors and the rear-view camera, and both of these devices are mutually compatible (whereas when buying separately, problems may arise). Rear-view cameras are used to allow the driver to see blind spots — primarily behind the car (hence the name), but "eyes" are also available for front / side view.
