Dark mode
Укр|Eng|Рус
Ukraine
Catalog   /   Climate, Heating, Water Heating   /   Water Supply & Pumps   /   Surface Pumps

Comparison Nasosy plus CPm 158 vs Nasosy plus CPm 146

Add to comparison
Nasosy plus CPm 158
Nasosy plus CPm 146
Nasosy plus CPm 158Nasosy plus CPm 146
Compare prices 16Compare prices 7
TOP sellers
Suitable forclean waterclean water
Specs
Maximum performance6500 L/h6100 L/h
Maximum head30 m25 m
Max. pressure6 bar6 bar
Pump typecentrifugalcentrifugal
Suction typeprimingpriming
Maximum particle size0.2 mm0.2 mm
Maximum liquid temperature40 °С40 °С
pH value6.5 – 9.56.5 – 9.5
Suction systemsingle-stagesingle-stage
Outlet size1"1"
Inlet hole size1"1"
Engine
Maximum power980 W780 W
Power sourceelectricelectric
Mains voltage230 V230 V
Engine typeasynchronousasynchronous
Power cord length0.5 m0.5 m
General specs
Protection class (IP)4444
Country of originUkraineUkraine
Pump housing materialcast ironcast iron
Impeller / auger materialbrassbrass
Dimensions310x193x240 mm305x178x225 mm
Weight13.5 kg13 kg
Added to E-Catalogoctober 2014october 2014

Maximum performance

The maximum volume of water that the device can pump in a certain amount of time. It is one of the key specs of any pump because characterizes the volume of water with which the device can work. At the same time, it does not always make sense to pursue maximum performance — after all, it significantly affects the dimensions and weight of the unit.

Some formulas allow you to derive optimal performance values for different situations. So, if the pump is designed to supply water to water intake points, its minimum required performance should not be lower than the highest total flow rate; if desired, a margin of 20-30% can be added to this value. And for sewer models (see "Suitable for"), everything will depend on the volume of wastewater. More detailed recommendations for choosing a pump depending on performance can be found in special sources.

Maximum head

The maximum head generated by the pump. This parameter is most often indicated in meters, by the height of the water column that the unit can create — in other words, by the height to which it can supply water. You can estimate the pressure created by the pump using a simple formula: every 10 m of head corresponds to a pressure of 1 bar.

It is worth choosing a pump according to this parameter, taking into account the height to which it should supply water, as well as adjusting for losses and the need for pressure in the water supply. To do this, it is necessary to determine the difference in height between the water level and the highest point of water intake, add another 10 to 30 m to this figure (depending on the pressure that needs to be obtained in the water supply), and multiply the result by 1.1 — this will be the minimum pressure required.

Maximum power

Rated power of the pump motor. The more powerful the engine, the higher the performance of the unit, usually, the greater the pressure, suction height, etc. Of course, these parameters largely depend on other features (primarily the pump type, see above); but models similar in design can be compared in terms of power.

Note that high power, usually, increases the size, weight and cost of the pump, and also implies high costs of electricity or fuel (see "Power source"). Therefore, it is worth choosing a pump according to this parameter taking into account the specific situation; more detailed recommendations can be found in special sources.
Price graph
Nasosy plus CPm 158 often compared
Nasosy plus CPm 146 often compared