Grunhelm GBH I-10V
 | Outdated Product 3 719 ₴ Type: storage; Energy source: mains; Tank volume (L): 10; Power source: 230 V; Power consumption (W): 2000; Magnesium anode; Heating elements: 1; wet heater; thermostat; overheat protection; safety valve; Pipe connection: bottom; Dimensions (cm): 36x27x28; |
 |
Close
We recommend products in stockWater Heaters Grunhelm →
tank, 10 L, 2000 W, magnesium anode, protection: from overheating, dry heating protection
Grunhelm GBH I-10V | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
The information in the model description is for reference purposes.
Always clarify the specifications and configuration of the product with the online store manager before purchasing.
Catalog Grunhelm 2025 - new arrivals, bestsellers, and the most relevant models Grunhelm.
Always clarify the specifications and configuration of the product with the online store manager before purchasing.
Catalog Grunhelm 2025 - new arrivals, bestsellers, and the most relevant models Grunhelm.
Which is better: wet or dry heating element in a water heater?Learning the design features, pros and cons of "wet" and "dry" heating elements in water heaters
Detailed FAQ on storage water heatersWe answer the most common questions regarding the installation and operation of storage water heaters
5 1 1 0 |
Disgusting. The first tank leaked, the warranty one did not work even for two years. Price. Manufacturing quality.  sergei bogach: use Grunhelm GBH I-10V more than year |
bought in September 2019 a device with one heating element of 1.5 kW and 15 liters. It has been operating continuously for the 9th month under the kitchen sink and immediately installed a pressure reducer with a manometer for monitoring. The safety valve (clearly reacts to pressure exceeding 6 bar) is placed over a 0.5-liter bowl on the top lid of the boiler, into which water simply drips and evaporates, result - never any leaks, so no tubes and jars are needed. it was about the problem with hot water and the existence of a boiler. It simply works and heats the water and retains heat pretty well. If there is no cold water in the system, the heating elements will not run dry as there is always water in the tank. so far, there are none, everything is satisfactory Vitaliy: |
I rarely write comments, but I would like to tell you all about this Chinese product. Pluses are written on each site: price, pseudo tank guarantee for 7 years, etc., stainless steel, compactness Cons: 1. There is NO magnesium anode in it; 2. Not one, but two one-kilowatt heaters; 3. A lot collects from the safety valve tube over the day. 4. In 2 years of operation, I used it for at most 2 weeks, and the tank leaked twice. During the first 2 weeks of operation, the tank leaked. With cries and pain, it was replaced in the service center (https://stroyteh.ua/contacts/) with a new one. Received a new one. Tested it. It seems to work. Partially drained the water. Closed the tap and it waited for better times. And then I fill it with water, create pressure, and it leaks again through the tank. So much for G5 welding technology and stainless steel. The 1-year warranty is already gone. 5. And what about the 7-year "pseudo" warranty? Dispatchers from the service center at https://stroyteh.ua/contacts/ nicely tell me that I am so bad for not going to them to change the magnesium anode (which is not there) every year for 300 UAH. Therefore, I apparently don't have a 7-year tank warranty. 6. Since the warranty is no longer valid, I tried to replace the gasket on the heaters. Thought perhaps the problem was with the gasket. Looked inside. And where parts of the boiler were welded, there are traces of rust in some places. So much for stainless steel + G5 technologies. use Grunhelm GBH I-15U more than year |
3 out of 7 user review(s) shown
4 more user review(s)
Additional features water heater Grunhelm GBH I-10V:
- Model GBH I-10U - under-sink installation
- Model GBH I-10V - over-sink installation