WD RE WD3001FYYG 3 TB SAS
![]() | Outdated Product 2 713 ₴ Internal (embedded) server hard drive of moderate capacity from the WD Raid Edition family of 3.5" HDD drives (capacity of family models varies from 1 to 4 TB). This line includes high-quality drives, the design and firmware of which are optimized for solving long-term storage problems in disk arrays and servers with up to 16 HDDs. SAS is used as the connection interface, so the WD RE WD3001FYYG hard drive cannot be installed in ordinary consumer and office PCs. It can only be used in SAS or SAS/SATA drives with hot-swappable support. or connect to the controller with an SFF-8482 cable (purchased separately). This model uses the traditional CMR magnetic recording method, which provides high speed data access, and the magnetic plates themselves rotate at a speed of 7200 rpm. The maximum dat...a transfer speed can reach 174. MB/s. When used intensively, it creates a noticeable noise level (up to 34 dB). With the proper level of active cooling, such a disk can be operated 24/7. Proprietary Rotary Acceleration Feed Forward balancing technology optimizes performance in the presence of vibration generated by multiple drives. The firmware of this drive is optimized for operation as part of RAID arrays and supports Time-Limited Error Recovery technology, which prevents the device from falling out of the array. |
WD WD3001FYYG | |||||||||||||||||||||||||||||||||||
|
Internal (embedded) server hard drive of moderate capacity from the WD Raid Edition family of 3.5" HDD drives (capacity of family models varies from 1 to 4 TB). This line includes high-quality drives, the design and firmware of which are optimized for solving long-term storage problems in disk arrays and servers with up to 16 HDDs. SAS is used as the connection interface, so the WD RE WD3001FYYG hard drive cannot be installed in ordinary consumer and office PCs.
It can only be used in SAS or SAS/SATA drives with hot-swappable support. or connect to the controller with an SFF-8482 cable (purchased separately). This model uses the traditional CMR magnetic recording method, which provides high speed data access, and the magnetic plates themselves rotate at a speed of 7200 rpm. The maximum data transfer speed can reach 174. MB/s. When used intensively, it creates a noticeable noise level (up to 34 dB).
With the proper level of active cooling, such a disk can be operated 24/7. Proprietary Rotary Acceleration Feed Forward balancing technology optimizes performance in the presence of vibration generated by multiple drives. The firmware of this drive is optimized for operation as part of RAID arrays and supports Time-Limited Error Recovery technology, which prevents the device from falling out of the array.
Always clarify the specifications and configuration of the product with the online store manager before purchasing.
Catalog WD 2025 - new arrivals, bestsellers, and the most relevant models WD.
8 8 15 52 |
I regularly buy such discs. This WD2004FBYZ series vibrates a lot. That is, if you hold it in your hand, it behaves like a children's toy with a cheap motor. After installing it in a heavy basket and a mega-heavy case, the entire case vibrates. The vibration is noticeable EVEN on the table next to the case!!! The WD2000FYYZ series also suffered from this problem, but it was noticed in one out of six to ten drives and the vibration was less powerful. However, the batch of drives purchased over the last couple of months all vibrate. There's one supplier to Ukraine. A suspicion has arisen that they're sending us fakes. Or (less likely) the manufacturer has lowered the quality requirements of the finished product by a couple of levels. I (and everyone who works with me) quickly dubbed these drives VIBRATING DISKS. When idle, these vibrating disks stop, and after accessing them, they quickly spin up. Even a deaf person would notice the noise difference. It's time to give them a rating. It's a tricky matter. Of course, such drives are primarily intended for "noisy" servers, where noise is not considered a criterion at all. BUT, as everyone understands (I hope so), "vibrating disks" work to the detriment of the bearing, and they certainly will not last the declared 2 million hours in the "fairy tales." And knowing this, WD still pushes (possibly only here) its vibrating junk. Therefore, I believe that consumers - that is, us - should "protest" and try to influence WD's future view of us with our protest. Almost everything!!! Mega vibrates (considering the expected quality from a leading company) i recommend it don't buy |
Overall, the disk is very reliable. But this is due to its positioning. And every self-respecting sysadmin should have a configured and fast network. The disk is definitely worth its money. There's a lot of good stuff here: fast speed (up to 6 Gb/s), full-duplex connection through 2 ports, prevention from dropping out of the array, vibration protection. Definitely - the disk is cool and reliable. No, there are no disadvantages. A good solution for the server room. use WD RE month or more i recommend it should buy |
i haven't had a single failure in a year of work. But I treat the hard drive carefully and try not to overstrain it =) warms moderately for stable operation it is better to install a program that will monitor the temperature. It does not heat up much, but still, it is better to know what and how is happening. The screw is large, there is a lot of information on it, so it will be a pity if it disappears ![]() |

WD RE WD3001FYYG configurations
Price for WD RE WD3001FYYG | ||||
---|---|---|---|---|
![]() | WD RE WD2001FYYG 2 TB SAS | from 1 561 ₴ | 5 offers | |
![]() | WD RE WD2004FBYZ 2 TB кэш 128/SATA | from 4 250 ₴ | 36 offers | |
![]() | WD RE WD4000FYYZ 4 TB cache 64/SATA | from 64 266 ₴ | 36 offers |