Drill driver Dnipro-M TD-60

Affordable cordless pistol drill/driver. The manufacturer is positioned as a model of the initial price category. Designed for domestic and moderate professional use in conditions of simple permanent access to the electrical network. It can be a great option for a regular household, auxiliary or replacement tool. The 600 W commutator motor provides a speed of up to 750 rpm and a maximum torque of up to 22 Nm.

The Dnipro-M TD-60 drill driver is capable of handling typical assembly, assembly / disassembly, various types of finishing and some construction work. High-quality keyless chuck provides quick tool change without the use of a key and other special devices. The minimum diameter of the installed drill is 1.5 mm, the maximum diameter is 10 mm. It is allowed to drill holes in steel with a diameter of up to 8 mm, the same operation in wood can be performed with drills with a diameter of up to 25 mm. Easily drives/unscrews screws up to 6x70 mm. For screwing threaded fasteners into soft materials (drywall, plastics, soft woods), a 16-position clutch is provided, which limits the maximum tightening torque. There is a convenient reverse switch and a sensitive electronic speed controller built into the switch trigger mechanism.

Good working tool

The Dnipro-M tool is positioned as "decent quality at an affordable price." And the Dnipro-M TD-60 screwdriver does not deceive the expectations of customers. It's actually cheap and built with quality parts.

This model has everything that is included in the "gentleman's set" for corded drills-drivers: a quick-release chuck for equipment with a diameter of 1 to 10 mm, a slide reverse for reverse and electronic speed control, combined with a trigger.

Good specs

A torque of 22 Nm is enough to confidently handle typical fasteners used in construction and decoration. For example, a screwdriver confidently drives self-tapping screws up to 6x70 mm into hardwood boards. For working with soft materials there is a 16-position clutch for adjusting the maximum tightening torque.

Despite the lack of a second speed, a screwdriver can be used as a drill (with certain reservations). It can drill wood, plastic and thin metal. But for drilling in concrete, it is better to choose a tool that has an impact mode.

At least now for work

The Dnipro-M tool is “sharpened” for fairly intensive work. It doesn't have the tendency to overheat that low-cost drills tend to have. To ensure the possibility of operation in dusty areas, the manufacturer quite generously fills the motor windings with heat-resistant varnish and uses rubber gaskets to protect the bearings from fine dust. This model is equipped with a 4 m rubberized elastic power cable, which allows you to move almost freely around the workshop or building site.

Based on the combination of qualities and characteristics, the Dnipro-M TD-60 drill driver can be recommended not only to home craftsmen, but also to builders or finishers.