The table below lists all the typical error codes that may appear on the information display of Whirlpool washing machines.

Error code Decryption
F01 No water enters the tank, or too little water has accumulated
F02 The aquastop was activated.
F03 Pump circuit fault
F04 Heating system fault.
F05 Temperature sensor fault.
F06 No signal from the tachogenerator.
F07 Motor circuit fault.
F08 Heater fault.
F09 Water overflow detected.
F10 Motor fault.
F11 Control boards communication fault.
F12 No heating, washing takes place in cold water.
F13 No fill or long fill with water.
F14 Invalid EEPROM values.
F15 Motor control unit fault.
F16 Control unit fault.
F18 Machine operation blocked due to unsuitable washing powder.
F19 Power supply system fault.
F20 Electronic circuit board fault.
F21 Control module fault.
F22 Heating circuit fault.
F23 Filling system fault, signal about empty or full tank.
F24 Overflow control system fault.
F26 Motor does not rotate.
F27 Motor rotation only in one direction.
F28 Motor operation fault.
F31 Software has not been updated via the Internet.
FDL Door lock is broken.
FDU The door is not closed tightly enough.
bdd Drum flaps are not closed properly.
FH Problem with water intake.
FA Water problem.
FP Water drain problem.
FOD The problem with the choice of detergent.
SUD The problem with the choice of washing powder.
Whirlpool Washing Machines