Kaiser MIG-315 Pro (95329)

Professional welders — appropriate equipment

Kaiser MIG-315 Pro is a professional welding machine. It differs from household equipment, first of all, in that it cannot operate from a conventional single-phase 220-volt network. He needs three phases and 400 V.

Let's look under the hood

The characteristics of the machine meet the needs of most welders. It can weld with electrodes (up to 6 mm in diameter) and two types of wire: ordinary (in a protective gas environment) and flux (without gas). The set of "on-board electronics" includes almost all kinds of "assistants": hot start, afterburner, protection against sticking of the electrode and open circuit voltage limiter (VRD). There is a place for installing heavy (up to 15 kg) coils of large diameter in order to lessen their rearrangement during operation. There is a special output with a voltage of 36 V on the back of the case, to which you can connect a gas cylinder reducer heater.

Semi-automatic for workshop or workshop

Asking the price of the device Kaiser MIG-315 Pro, you should remember that it is designed for stationary use. After all, it will not work to carry large and heavy (23 kg) equipment back and forth, and it does not have transport wheels. This device is best suited for those who are professionally engaged in welding and work in a specially prepared room. The device is not cheap (price in the region of $ 500 is a very impressive cost by the standards of welding inverters), but professional welders have to invest in good equipment, like Kaiser equipment, in order not to be left without a device at the most inopportune moment.